Contact – Cell Site Automation, Remote Equipment Monitoring, Generators, Access Control, Site Security
From Asentria Portal

This instruction sheet describes the connection to the -48VDC or 24VDC Power Card and features a Phoenix terminal block with screw clamp connectors.

This instllation guide provides the necessary information for installing the optional -48VDC Power Supply Card (/DC card) into an Asentria SiteBoss 550, SiteBoss 530, TeleBoss 850, or TeleBoss 830 product.

This document explains the installation of AC Power sensor to be used for monitoring up to 120 VAC.

Instructions for installing the Alarm Button Kit

This article describes the installation and operation of the optional backup battery module.

This article describes the configuration and use of an IP camera alarming using Asentria products.

This guide assists in the installation of a new System Sensor Carbon Monoxide Detector (ESC-CO1), and integration with a SiteBoss or TeleBoss unit.

The DC Current Transducer is used to monitor DC current flow. This document gives installation and configuration instructions.

This article gives instructions for connecting a laptop or a desk top computer directly to the Eth1 or Eth2 ports on a S550 or a T850.

Installation and configuration instructions for the Resistive Fuel Sensor Adapter

ES-Surge installation and data sheet

Installation Instructions for the ESC-SM3 Smoke Detector (5000-062)

This guide provides information needed to properly mount and connect an ESJ-HUB SensorJack Expansion Hub for use with SiteBoss or TeleBoss products.

The ES-6INJ EventSensor Power Injector can be used to add power to extend the length of any ES Sensor chain.

This article describes the correct procedures for field installation of Expansion Cards in Asentria products.

Asentria Base units have a wide variety of Expansion cards that can be added to our two and six expansion card base units. This makes are units do exactly what a customer needs and reduces cost, since you do not have to buy what you don't need.

Instructions for physical installation and access configurations when using an Asentria-provided Gas Pressure Switch.

This article describes the optional GPS card, its interface with the host unit, and applicable settings.

This guide provides information needed to properly connect and configure a high density expansion card and cable for use with SiteBoss or TeleBoss products.

This document gives instructions for installing a SIM into a ML1V or an ML1P 4G Wireless Modem and getting the basic settings configured to connect to the wireless network.

This note briefly describes the basic integration between Intermapper and Asentria SiteBoss monitoring devices.

This guide provides information needed to properly install and configure an outdoor door sensor for use with SiteBoss or TeleBoss products.

This manual provides basic installation and operation details, a quick start guide, general information, and documentation on commands and interface methods for the PowerBoss External 30 Amp Relay - Installation Guide.

The Slimline Relay provides a simple means of verifying AC voltage is present or switch AC or DC power on or off.

The Rochester Removable Dial Fuel Gauges are used to remotely monitor the fuel level of a diesel or propane fuel tank.

This feature guide shows the pinout for our RJ45 Serial Ports on the TeleBoss and SiteBoss units. The DCE and DTE adapter wiring pin outs is also covered.

Installation instructions for power and relay harness on the SiteBoss 570

The User guide basic specifications, installation instructions and configuration information.

These steps will allow you to log into your SiteBoss remotely using this External 4G Modem from anywhere that has Internet access.

This is a form that is used to help installation technicians or Asentria Sales engineers evaluate the SiteBoss configuration and equipment needed for an individual stationary site.

This guide provides information needed to properly install a smoke sensor for use with SiteBoss or TeleBoss products.

Instructions for physical installation and access configurations when using a Wiegand access card reader and the Asentria Wiegand Card Reader SiteBoss Interface.